Our 50-Ohm flange-mount RF connectors are designed for use in military and commercial applications where environmental conditions require an extremely rugged and reliable hermetic seal. Low-loss Corning 7070 glass is used for dependable electrical performance. PacAero manufactures these flange-mount RF connectors from a variety of compatible shell and contact materials, in both laser weld and solder-in styles, which provide excellent electrical and environmental performance characteristics.
Download Datasheet
Flange-mount RF Connector Specification and Testing Configuration
| Specifications | Material Compatibility | Designed for Aluminum, Titanium or Iron/Nickel Alloy Applications |
|---|
| Contact Material | Iron/Nickel Alloys |
|---|
| Shell Finish Options | Passivated, Nickel/Gold Plated or Chromate Conversion Coated as applicable |
|---|
| Contact Finish | Nickel/Gold Plating |
|---|
| Pin Diameter Options | .012″, .015″, .018″, .020″ and Custom |
|---|
| Interface | Per MIL-STD-348 |
|---|
| Nominal Impedance | 50 Ohms |
|---|
| Performance | Leak Rate | Less than 1×10-9cc/sec Helium at 1 atmospheric differential pressure |
|---|
| Thermal Cycling | Tested to 500 (minimum) thermal cycles without hermetic performance loss |
|---|
| Insulation Resistance | Connectors provide greater than 5,000 Megohms at 500 VDC when tested in IAW MIL-STD-1344, Method 3003 |
|---|
| Dielectric Withstanding Voltage | Connectors exhibit no evidence of breakdown or flashover when tested in IAW MIL-STD-1344, Method 3003 |
|---|
| Corrosion | Connectors meet salt spray test in IAW MIL-STD-1344, Method 3003 |
|---|
| Operating Temperature | -65°C to 200°C |
|---|