Push-On RF Connectors
Our 50-Ohm hermetic LWP®, LLWP®, SMP and SSMP feedthru RF/Microwave connectors are designed for use in military and commercial applications where environmental conditions require an extremely rugged and reliable hermetic seal. Low-loss Corning 7070 glass is used for dependable electrical performance. SOURIAU PA&E manufactures these connectors from a variety of compatible shell and contact materials, in both laser weld and solder-in styles, which provide excellent electrical and environmental performance characteristics.
Download RF/Microwave Connectors Data Sheet (PDF 267 KB)
Push-On Connector Specifications and Testing Configuration
|
PERFORMANCE CONFIGURATIONS |
PUSH-ON |
|
LWP® |
LLWP® |
SMP |
SSMP |
|
SPECIFICATIONS |
MATERIAL COMPATIBILITY |
Designed for Aluminum, Titanium or Iron/Nickel Alloy applications |
|
CONTACT MATERIAL |
Iron/Nickel Alloys |
|
SHELL FINISH OPTIONS |
Passivated, Nickel/Gold Plated or Chromate Conversion Coated as applicable |
|
CONTACT FINISH |
Nickel/Gold Plating |
|
PIN DIAMETER OPTIONS |
.012", .015", .018", .020" and Custom |
|
INTERFACE |
Per MIL-STD-348 |
|
NOMINAL IMPEDANCE |
50 Ohms |
|
PERFORMANCE |
LEAK RATE |
Less than 1X10-9cc/sec Helium at 1 atmospheric differential pressure |
|
INSULATION RESISTANCE |
Connectors provide greater than 5,000 Megohms at 500 VDC when tested in IAW MIL-STD-1344, Method 3003 |
|
DIELECTRIC WITHSTANDING VOLTAGE |
Connectors exhibit no evidence of breakdown or flashover when tested in IAW MIL-STD-1344, Method 3003 |
|
CORROSION |
Connectors meet salt spray test in IAW MIL-STD-1344, Method 3003 |
|
OPERATING TEMPERATURE |
-65°C to 200°C |
|
